Gear Cards Tray Assembly
Gather all these parts, orient them as shown. Glue up the outside edges first, then the long middle divider. Afterwards the two short dividers just slot into place.
Token Tray Assembly
Here is all the parts, one long divider (2 shown on bottom) is missing from these photos.
Make sure you're doing alignment like shown
Watch out for the slots being in the correct places, as mentioned in this picture.
Put up the sides and the long middle section.
Don't put the short middle section in yet, as you'll want the support for it in first.
Finished Token Tray
Note there is a long divider that's missing (should be in the middle right of the photo). This is included in your kit, was missing for this photo.
Monster Card Tray Assembly
Setup the tray as show in this image. 3 copies of this tray included! Glue up the outside edges then put the divider down in the middle.
It's just a simple matter of gluing all the outside edges up then dropping in the divider.
Gear Grid Assembly
Grab out the pieces and arrange then as so. They just glue in right where you see them. There is something to look out for, see next image!
There are short and long lengths, 4 short and 2 long per gear grid (so 16 and 8 in total). We use the long ones on the top and bottom then the short ones for the other 4 spots, the only thing to watch for is making sure you use 2 long ones (and only 2!) on the outside edges.